Friday, July 12, 2013

I'm hooked: a DIY hanging station

So you know all those beautiful knobs and drawer pulls that are all over the place now? I have a slight addiction. I pick them up all over the place and have a stash ready for when a project pops into my head. Like this one. A sweet little hanging station for behind the door.

This version is simple. All I did was cut a piece of pallet board down to the size I needed, and drilled three holes clear through, large enough for the hardware on my drawer pulls to fit through. The tricky part is drilling a hole large enough to fit the nut on the backside, but only halfway through the board. You want to be able to make your hardware completely flush with the back of the board so it hangs nice and smooth on the wall.

When I had all the pulls/knobs tight on the board, I took a metal saw blade on my Dremel and cut off the backs of the screws that were sticking out past my board. I didn't take pictures along the way, but I'm sure I'll be making more of these, so I'll try to remember to document the steps next time.

So after about 15 minutes, I had myself a custom hanging station for the guest room. Give it a shot, they're extremely easy. And I just hung mine up with a couple of drywall screws that you really can't see unless you're looking too close...


No comments:

Post a Comment